Arthur
Hello!
I recently ordered a pack of Polywarmton baryta paper. Before that, I’d been using Agfa MCC 111.
I’m actually quite happy with the ADOX paper, but I’ve noticed that it seems to need a longer development time than the Agfa MCC, which I always developed for 90 seconds (developer: Neutol NE 1+7 at 20°C; I used the same one for the ADOX as well).
Does anyone perhaps have experience with this paper-developer combination and can give me some advice on development time?
Thanks, Arthur
FrankJBeckmann
Hi there,
The Polywantone needs to be developed for 4 minutes. It doesn’t matter which developer you use. Sure, with some developers it might take half a minute less, but 4 minutes is the safe bet. Then it’ll turn out beautifully.
Bye
Frank
Arthur
Oh, right, thanks a lot, Frank! I only spent two minutes on it... :)
